Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Datenbogen

Produktcode

1-F8075

142

<Model Menu (Airplane/Glider Functions)>

● Select the function name

and return to the Model

menu by touching the

R T N b u t t o n . 　 O r t h e

H O M E / E X I T b u t t o n i s

pushed.

<SensorTouch™>

RETURN

MOTOR

[Corresponding model type]: Airplane/glider, general

This function lets you set the speed when the

motor of an F5B or other EP glider is started via

a switch. The operation speed can be set for two

ranges, slow speed flight and high speed flight

(Speed 1/Speed 2). This function can also be

operated as a safety function by programming it to

a switch.

● The In side and Out side operating speeds can

be adjusted independently in 2 ranges (Speed 1/

Speed 2).

● The boundary between the 2 ranges can be set.

(From Speed 1 to Speed 2)

● The operational speed can only be activated at

the initial operation. However, operation can be

repeated by setting the switch to OFF before the

operation is finished. When you want to reset one

time operation, set the ACT/INH item to [INH] and

then reset it to [ON].

● The motor channel is controlled by SW-G. (Glider:

Initial setting) When changing the switch or stick

which controls the motor, first change Function of

the Linkage menu.

● If the Model Type selected is Airplane, the MOTOR

function is changed from INH to ON and it is not

assigned to another channel, the changes from

the throttle channel to the motor channel are
enabled.

Note: Initial setting does not assign a motor

channel according to the model type. Prior to

assigning the motor channel, find an unused

channel. Then, use the Function menu of the

Linkage menu.

Set [Control] to the switch you want to use

and [Trim] to [--].

Note: When using this function, always check

the initial operation with the propeller

removed.

● Select [MOTOR] at the Model menu

and access the setup screen shown

below by touching the RTN button.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

Setting method
● Activate the function

When using this function, move the cursor to

the [ACT/INH] item and touch the RTN button

to switch to the data input mode. Select the

[ACT] by scrolling the touch sensor and touch

the RTN button.

When selecting the ON/OFF switch, move the

cursor to the switch item and touch the RTN

button to access the selection screen. Select

the switch and set its ON direction. (Always

ON at "--" setting)

*For a description of the switch selection method, see the

description at the back of this manual.

● Motor off position setting

Move the cursor to the [MOTOR OFF] item

and touch the RTN button for one second

when the motor function switch (SG, etc.) is

in the motor OFF position you want to set. The

direction of the motor switch is memorized.

The screen graph display OFF direction also

changes.

Note:
● First decide the motor OFF direction, and then

set the speed. When you want to reset the

motor OFF direction, also reset the speed.

● We recommend that Motor OFF be set in

combination with F/S.

● Set the basic operation direction with the

Reverse function to match the ESC used.

● Always set the Motor OFF position.