Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Datenbogen

● Select the function name 

and return to the Model 

menu by touching the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s 

pushed.

ELEVATOR

ELEVATOR 2

(AILERON 5)

(AILERON 6)

[Corresponding model type]: Airplane/glider, Ailevator

       (Effective only when 2 servos used at the elevators)

This function improves the performance of the roll 

axis by operating the elevators as ailerons.

Ailevator is where each elevator in a standard 

(conventional) or v-tail moves independently, like 

ailerons on a wing. In addition to each elevator side 

moving up and down together, each side moves in 

opposite directions when moving as an Ailevator. On 

a V-tail, this is also known as a Ruddervator, as they 

can serve the same purpose. Typically, both Ailevator 

and ailerons are coupled together to maximize roll 

performance, especially on larger wingspan planes.

Note: Select Ailevator as the Model Type at the Model 

Type screen. This changes the output channel. Check 

the Function menu.

(Aileron function)
● When the elevators are used 

as ailerons, aileron travel of 

the left and right elevators 

can be adjusted.

(Elevator function)
●  The  up  and  down  rate  of  both 

elevators when the elevator stick 

is moved can be individually 

adjusted.

● Select [AILEVATOR] at the Model menu 

and access the setup screen shown 

below by touching the RTN button.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

  Move the cursor to the item you want to 

adjust and touch the RTN button to switch to 

the data input mode.

  Adjust the rate by scrolling the touch sensor. 
  Initial value: ELE: +100%, AIL: 0%
  Adjustment range: -120~+120%

*When the RTN button is touched for one second, the rate is 

reset to the initial value.)

  Touch the RTN button to return to the cursor 

mode.

*If the mixing direction is reversed, adjustments can be made 

by changing the mixing rate polarity (+ or -).

*If a large value of travel is specified, when the sticks are 

moved at the same time, the controls may bind or run out of 

travel. Decrease the travel until no binding occurs.