Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Datenbogen

Produktcode

1-F8075

<Model Basic Setting Procedure>

MODEL BASIC SETTING PROCEDURE

1. Model addition and selection

Initially, the T14SG assigns the first model to

model-01 in the transmitter. The Model Select

function of the Linkage Menu is used to add

models and to select amongst models which are

already set.

The T14SG is capable of storing data for up

to 30 models in its internal memory. Additional

model data can also be saved to an optional SD

card.

The currently selected model name is displayed

in the center of the home screen. Before flying and

before changing any settings, always confirm the

model name.

When a new model is added, the Model type

select screen and System mode setup screen

automatically appear. Please be aware that the

transmitter will stop transmitting temporarily when

you change the model.

When a new model is added, you will need to re-

link the receiver.

2. Model type selection

Select the model type matched to the aircraft

with the Model Type select function of the Linkage

Menu. For an airplane, select the model type from

among the 2 types: airplane and glider. And then

select the wing type and the tail type matched to

the aircraft.

Airplane/glider basic setting procedure

3. Fuselage linkage

Connect the ailerons, elevators, throttle, rudder,

etc. in accordance with the model's instruction

manual. For a description of the connection

method, see the Receiver and Servos Connection.

Note that even for the same "airplane

model", when the wing type and tail type

are different, the channel assignment may

be different. (The channel assigned to each

function can be checked at the Function

menu of the Linkage Menu.)

● If the direction of the servo is incorrect, adjust

the direction with the Reverse function of the

Linkage Menu.

● Adjust the neutral position and control

surface angle with the linkage, and fine

tune them with the Sub-Trim and End Point

functions (angle adjustment). To protect the

linkage, a limit position can also be set with

the End Point function. The End Point function

can adjust the amount of up/down and left/

right movement and limit of each channel.

4. Throttle cut setting (Airplane)

Throttle cut can be performed with one touch by a

switch without changing the throttle trim position.

Set throttle cut with the Throttle Cut function of

the Linkage Menu. After activating the throttle cut

function and selecting the switch, adjust the throttle

position so that the carburetor becomes fully closed.

For safety, the throttle cut function operates the

throttle stick in the 1/3 or less (slow side) position.