Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Datenbogen

Produktcode

1-F8075

<Model Basic Setting Procedure>

5. Idle down setting (Airplane)

The idling speed can be lowered with one touch

by a switch without changing the throttle trim

position. Perform this setting with the Idle Down

function of the Linkage Menu. After activating the

Idle Down function and selecting the switch, adjust

the idle down speed. For safety, the idle down

function acts only when the throttle stick is in the

lowest part of its throw.

*While the Throttle Cut function is in operation, the Idle

Down function does not work.

6. D/R function

D/R function is used to adjust the throw and

operation curve of the stick functions (aileron,

elevator, rudder and throttle) for each switch

position (airplane) or each flight condition (glider).

This is normally used after the modeler has defined

the maximum throw directions in the End Point

settings.

(Airplane)

(Glider)

7. Airbrake (Airplane)

This function is used when an airbrake is

necessary when taking off or diving, etc. Please

note: this menu item is only available under certain

wing configurations. For example, it will not appear

if a single aileron wing type has been selected.

The pre-set elevator and flap offset amount can

be activated by a switch.

The offset amount of the aileron, elevator, and

flap servos can be adjusted as needed. Also the

speed of the aileron, elevator, and flap servos can

be adjusted. You can also set the Auto Mode, which

will link Airbrake to a stick, switch, or dial. A

separate stick switch or dial can also be set as the

ON/OFF switch.

8. Addition of flight conditions (Glider)

The Condition Select function automatically

allocates the normal condition (NORMAL) for

each model. NORMAL is the default condition and

is the only one active when a new model type is

defined.

If you want to add flight conditions, please refer

to a description of the CONDITION function.

*The NORMAL is always on, and remains on until other

conditions are activated by switches, stick positions, etc.

Please refer to the section entitled Switch Selection Method

for additional information on how to do so.

*It is possible to customize the activation of the flight

conditions.

*The Condition Delay can be programmed for each channel.

The Condition Delay is used to change the servo throw

smoothly when switching conditions.