Beurer Tageslichtlampe TL 40 608.20 Datenbogen
Produktcode
608.20
63
Guidance and manufacturer’s declaration – electromagnetic emissions
The “Mini Daylight” is intended for use in the electromagnetic environment specified below. The
customer or the user of the “Mini Daylight” should ensure that it is used in such an environment.
Emissions test
Compliance
Electromagnetic environment – guidance
RF emissions
CISPR 11
Group 1
The “Mini Daylight” uses RF energy only for its
internal function. Therefore, its RF emissions are
very low and are not likely to cause any interfe-
rence in nearby electronic equipment.
RF emissions
CISPR 11
Class B
The “Mini Daylight” is suitable for use in all
establishments, including domestic establish-
ments and those directly connected to the public
low-voltage power supply network that supplies
buildings used for domestic purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Complies
Recommended separation distances between
portable and mobile RF communications equipment and the Mini Daylight
The “Mini Daylight” is intended for use in an electromagnetic environment in which radiated RF disturbances
are controlled. The customer or the user of the Medical Daylight can help prevent electromagnetic interference
by maintaining a minimum distance between portable and mobile RF communications equipment (transmit-
ters) and the “Mini Daylight” as recommended below, according to the maximum output power of the commu-
nications equipment.
Rated maximum output
Rated maximum output
power of
transmitter W
Separation distance according to frequency of transmitter m
150 kHz to 80 MHz
80 MHz to 800 MHz
800 MHz to 2,5 GHz
0,01
0.12
0.12
0.23
0,1
0.38
0.38
0.73
1
1.2
1.2
2.3
10
3.8
3.8
7.3
100
12
12
23
For transmitters rated at a maximum output power not listed above, the recommended separation distance d
in meters (m) can be estimated using the equation applicable to the frequency of the transmitter, where P is
the maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorpti-
on and reflection from structures, objects and people.
d = P
3,5
V1
[
]
d = P
3,5
E1
[
]
d = P
7
E1
[
]