VIVOTEK Vivotek Network Router ND4801 Benutzerhandbuch

 

 

1. The system power on self test and OS initialization takes about 2 minutes to complete. Once 

your NVR is started, you will be prompted by the 

Setup Wizard. You should then begin the 

initial setup. The system is booted from an embedded IDE flash. No software installation is 

required.  

2. Enter the default User name and Password as 

admin & admin. It is recommended you 

change the password later to prevent unauthorized access.   

3. Click 

Next to proceed with configuration and follow the onscreen instructions to finish the 

configuration process. 

 

4. Note the following when you move to the 

Network page: 

4-1. If your local network has a DHCP server, you can select the "

(DHCP)."  

4-2. If your LAN port connects to an isolated switch with cameras attached to it, you can 

manually assign IP addresses to cameras, and the address for the LAN port itself.  

The default static IP for the LAN port is 192.168.1.10.

1. During boot-up, a Startup Menu will prompt allowing you to restore system to factory defaults. 

This function is only required in circumstances that you need to renew all system settings, 

such as moving the NVR to a different installation site or network environment. 

2. You must install at least one hard drive for the initial configuration. Otherwise, the LiveClient 

console will not start. 

1.   NVR System