Intel IQ80321 Benutzerhandbuch
Board Manual
89
Intel
®
IQ80321 I/O Processor Evaluation Platform
Getting Started and Debugger
B.2
Setup
B.2.1
Hardware Setup
Use
and the rest of the Intel
®
IQ80321 Evaluation Platform Board Manual, to set up the
hardware.
•
Connect the Raven to the host via the parallel port and to the evaluation board via the 20-pin
JTAG connector.
JTAG connector.
Note:
The parallel port must be configured to EPP mode for the Macraigor Raven to work properly.
The parallel port setting can be changed in the BIOS setup program or in Control Panel. More
information on the Raven can be found at the Macraigor web site. Test software for the Raven is free
and available for download at:
information on the Raven can be found at the Macraigor web site. Test software for the Raven is free
and available for download at:
•
Connect a serial cable from the evaluation board to the host.
Note:
The serial cable connects to the evaluation board with an RJ11 connector and connects to the host
computer serial port via an RJ11 to DB9F adaptor. The serial port configuration is covered in the
configuration section below.
computer serial port via an RJ11 to DB9F adaptor. The serial port configuration is covered in the
configuration section below.
•
The IQ80321 plugs into a bus master PCI or PCI-X slot on the backplane or platform.
Note:
There are many dip switches on the evaluation board which are used to configure the IBM bridge. Use
the dip switch and jumper sections of the Intel
the dip switch and jumper sections of the Intel
®
IQ80321 Evaluation Platform Board Manual, section
3.10.2 to configure these switches. A work sheet is highly recommended when working out the switch
settings, Since there are a large number of switches, a record of the settings and the reasons for their
selection very useful. Check the system requirements of Microsoft Visual Studio and ATI Code|Lab to
make sure that the host is sufficient. The platform or backplane must have a 3.3 volt PCI-X or PCI slot.
The evaluation board is not 5 volt tolerant and damage occurs when 5 volts are applied.
settings, Since there are a large number of switches, a record of the settings and the reasons for their
selection very useful. Check the system requirements of Microsoft Visual Studio and ATI Code|Lab to
make sure that the host is sufficient. The platform or backplane must have a 3.3 volt PCI-X or PCI slot.
The evaluation board is not 5 volt tolerant and damage occurs when 5 volts are applied.
Figure 28.
Intel
®
IQ80321 Hardware Setup Flow Chart
Serial Cable
Parallel Port Cable
20-Pin JTAG Connector
Host
JTAG
Evaluation Board
Backplane or PCI-X Platform