Henkel LOCTITE 97504 Benutzerhandbuch
88
8 Technical Specification
Only adept maintenance staff may accomplish work inside
the equipment!
the equipment!
8.2
Terminal Block Pin Assignment X1, X2 and X3
The terminal strips are located within the control cabinet. All terminals are labelled in
accordance with the following table. Only authorised and properly qualified service
staff as defined in Section 2.4.2 must be permitted to open the control cabinet.
accordance with the following table. Only authorised and properly qualified service
staff as defined in Section 2.4.2 must be permitted to open the control cabinet.
8.2.1
Terminal Block X1 Motor A (only for Information)
Signal
internal
external
1
+24V
Power supply
Pressure switch Part A 1
2
+24V
Power supply
Limit switch container A sw
3
+24V
Power supply
Motor cable red
4
+24V
Power supply
5
Right rotation
Q1
Motor cable blue
6
0-10 Volt
Pot centre green
Motor cable pink
7
Motor A OK
I3
Motor cable white
8
Overpressure
A
A
I1
Pressure switch Part A 2
9
Container A
empty
empty
I5
Limit switch container A rt
10
GND
Power supply
Motor cable A sw
11
GND
Power supply
Pot GND white + shield / Z1
12
Left rotation
Q2
Motor cable yellow
13
Analogue
GND
GND
Power supply
Motor cable purple
14
+8Volt
Stabiliser 7808
Pot + brown / Z2