Whirlpool Washer/Dryer 4322616 Benutzerhandbuch

Seite von 132
50
Agitator Replacement
Refer to Figure 13 for these procedures.
1.  Open the lid of the washer.
2.   Loosen the hex head screw in the agitator access
       hole.  DO NOT REMOVE THIS SCREW.
3.   Pull the agitator off the splined agitator shaft.
4.   Position  the new agitator over the splined
       agitator shaft and turn it until the splines mate prop-
       erly and  press down on the agitator until it slides
       down the shaft as far as it can go.
5.  Retighten the hex head screw securely.  Do not
      overtighten it or the threads will strip.
Fig. 13
Basket Removal
Refer to Figures 14 and 15 for these procedures.
1.   Remove the agitator.
2.   Remove the top assembly.
3.   Unsnap eight snap clips holding the tub ring to the tub and set the tub ring aside.
4.   Loosen the drive hub screw by four or five turns.  DO NOT REMOVE THIS SCREW.
5.   Tap on the head of the drive hub screw to loosen the saddle block.
6.   Pull up on the basket and remove it from the tub.
Fig. 14
Fig. 15
AGITATOR
HEX-HEAD SCREW