Whirlpool Washer/Dryer 4322616 Benutzerhandbuch

51

1.   If a new basket is being installed, remove the drive hub from the old basket and install it on the new
      one.

2.   Lift the basket into the tub and carefully slide it over the spin tube.  Rotate the basket until the
       locator ears drop into the slots in the drive hub.  The basket rests on top of the spin tube.

3.   Tighten the saddle block screw.

4.   Be sure the snubber straps are positioned on the studs of the tub.

5.   Position the tub ring over the top of the tub so the overflow hose is positioned inside the washer
       properly and the overflow cover fits over the overflow cup.  Align the tabs on the tub ring over the
      snubber studs and snap the tub ring onto the tub.

1.   Remove the agitator.

2.   Remove the top assembly.

3.   Remove the basket.

4.   Lay the washer on its front on a soft surface to protect the cabinet finish.

5.   Remove the four hex head bolts from the tub support.

6.   Disconnect the drain hose from the pump.

7.   Using fingers and thumbs as a wedge, push the tub forward until it pops off the rubber seal at the
       bottom center of the tub.

8.   Stand the washer upright.

9.   Disconnect the water inlet hose from the water inlet valves and remove the plastic straps securing
       the inlet hose to the cabinet.

10.  Lift the entire tub assembly from the washer cabinet.

11.  If the tub is to be replaced with a new one, remove the pressure hose, liquid bleach dispenser
        hose, metal motor shield  and drain hose from the tub.

Fig. 16

Fig. 17

Mounting

Bolts

Mounting

Bolts