Wegener Communications 6400 Benutzerhandbuch

800009-03 Rev. A

8

Professional Video

Professional Video

5

800009-03 Rev. A

The liquid crystal display (LCD) provides menu, data, and input

screens to the user. Menu screens are entry points to further

screens showing signal or unit status or to user-input screens that

can be changed by the user. The "home" screen displays the

 unit's 

, 

, and alternately displays 

, 

, and 

. This screen may be

reached at any time by repeatedly pressing the 

 button.

Six pushbuttons allow you to move through the various screens,

select characters for input, and accept or reject changes. To move

downward or upward through the menu screens, use the 

and 

 buttons. To enter or change data in editable fields, press

the 

 button and use the up r

 and down s

 arrow buttons to

increment the highlighted character or digit. Use the right w

 and

left v

 arrow buttons to move to adjacent digits and press 

again to accept your input. Pressing 

 before accepting your

input will cancel any changes.

Eight light-emitting diodes (LEDs) illuminate to show unit status

at a glance. 

 gives the meaning of each LED indicator.

GREEN constant

Receiver is tracking carrier.

GREEN  slow blink

Receiver is not tracking carrier.

GREEN constant

 is recording a program.

Off

 is not recording.

GREEN constant

 is downloading a file via Compel.

Off

 is not downloading.

GREEN constant

Light network activity over the iPump's LAN
interface.

GREEN  slow blink

Heavy network activity over the iPump's LAN

interface.

Off

 observed no packet transfers during the

last 20 secs.

GREEN constant

 has received a Compel command

within the last two minutes.

GREEN    fast blink

 has been addressed by Compel within

the last five seconds.

GREEN  slow blink

 is in tracking mode and Compel is

required but no Compel command received
within the last two minutes.

4. Next, start your iPump

 

as follows:

Connect the ac power cord to the 

's IEC

receptacle (

, 

) and to a 100-to-120-Vac or 200-to-240-

Vac source.

Set the power switch to the On position ( I ) and

press and hold the 

 button on the front panel for two

seconds. The 

 will power up and begin the boot process.

Outputs are muted during the short initialization time. All eight

LED indicators flash on and off as the unit begins initialization.
Until you configure your 

's RF settings (see Step 

), a

loss-of-carrier alarm may be displayed (red 

 LED

indicator is lit and LCD screen indicates the alarm state). RF

settings are not necessary for units with the optional ASI input.

Note: To easily restart the 

 any time after a normal shutdown

(see Step 

9

), simply press the 

 button on the 

’s

front panel (refer to the 

l for details). If the

receiver is tracking a carrier signal, the green 

 LED

will light.

5.  Get to know the iPump's front panel