Z Microsystems 19 Benutzerhandbuch

Doc# 27-0023UM Rev 1.0 Issued 09/04

INSTALLATION

NOTE: For the fastest and easiest

installation of the Command
Console, follow these steps
in the sequence they are
presented.

Ensure all of the following parts are in-
cluded in the package received from Z Mi-
crosystems. Verify all parts have not been
damaged during shipment. If any of the
parts are missing or damaged, immediately
contact Z Microsystems Customer Service
at 858-657-1000.

• Command Console unit attached to the
mounting plate

• Hardware kit

• Manual

• Power Supply Cable

• Video Signal Cable

• Serial I/O Cable

• CD of SoftMenu software

SHIPMENT CONTENTS

Remember to save the unit’s original
shipping materials. It may be necessary to
move the unit at a later date.

TOOLS REQUIRED

PRECAUTIONS

• Required Tools and Equipment

• Flathead screwdriver with about 10”
shaft.

• Phillips screwdriver with about 10”
shaft.

In preparation to install the Command Con-
sole, take the following precautionary step:

Turn off the electrical power to your com-
puter.

DANGER: To avoid shock
hazard:

• Do not remove the covers around the
Command Console.

• Do not connect or disconnect the
Command Console during an electrical
storm.

• Th

e power cord plug must be connected

to a properly wired and grounded power
outlet.

• Any equipment to which the Command
Console will be attached must also be
connected to properly wired and grounded
power outlets.