Z Microsystems 19 Benutzerhandbuch

Doc# 27-0023UM Rev 1.0 Issued  09/04

7

With the Console sitting 
on a workbench with the 
front facing towards you, 
press down to release the 
Z-Locks on each side of the 
front of the Console to slide 
the side rails back.

The slide rail will reach a 
stop about half way back.

This is a safety stop to 
prevent the Console from 
sliding out too far while 
mounted to the rack.

Simultaneously press in 
the safety catches on each 
slide rail and slide the side 
rails all the way off the back 
of the Console. 

On the front of the cabinet 
frame, use three Phillips 
screws on each side to 
secure the right and left 
Z-Lock mounts. 

DO NOT tighten these 
screws to allow for adjust-
ment of the Console within 
the cabinet  frame.

On the rear of the cabinet 
frame, use three Phillips 
screws to loosely secure 
the right and left rear slide 
mount to the cabinet frame.

DO NOT tighten these 
screws fully at this time.

The slides should now 
be separated from the 
Console.  

Each slide unit  includes 
the slide rail, with the front 
Z-lock mount and the rear 
mount. 

On the slide rails, using a 
slot screwdriver, loosen 
off the slide extension rail 
screw. Repeat on each 
side.