Vanguard Managed Solutions Vanguard 7300 Series Benutzerhandbuch
5-20
Modifying Your Vanguard 7300
Removing and Replacing Carrier Expansion Cards and Mezzanine Cards (PMCs)
Installing Ethernet PMCs on the Carrier Expansion Card
Introduction
This section describes how to install PMCs on the Carrier Expansion Card. The
Carrier Expansion Card provides two slots for Ethernet PMCs. The PMCs that can
be installed on the Carrier Expansion Card are 10/100 BaseT Ethernet PMCs.
Figure 5-12 shows the Carrier Expansion Card PMC locations.
Carrier Expansion Card provides two slots for Ethernet PMCs. The PMCs that can
be installed on the Carrier Expansion Card are 10/100 BaseT Ethernet PMCs.
Figure 5-12 shows the Carrier Expansion Card PMC locations.
Figure 5-12. PMC Slots on the Carrier Expansion Card
Populating the
Carrier Expansion
Card
Carrier Expansion
Card
When installing Carrier Expansion Card PMCs, install a PMC in the first slot, slot 1,
the lefthand slot, before you install a second PMC in the Slot 2 on the right.
the lefthand slot, before you install a second PMC in the Slot 2 on the right.
Installing a Carrier
Expansion Card
PMC
Expansion Card
PMC
Use the steps in this table to install a Carrier Expansion Card PMC:
Note
To remove an Ethernet PMC from a Carrier Expansion Card, remove the four
short screws at the corners of the PMC and remove the PMC from the card
connectors.
short screws at the corners of the PMC and remove the PMC from the card
connectors.
Ethernet
PMC
Serial No.
Locations
Serial No.
Location
PMC Slot2
PMC Slot1
Step
Action
1
Remove the Carrier Expansion Card from the enclosure according to the
instructions provided in “Removing the Carrier Expansion Card” section
on page 5-19.
instructions provided in “Removing the Carrier Expansion Card” section
on page 5-19.