Utica Boilers UB95M-200 Installationsanweisungen

Seite von 52
1 - Dimensions ..............................................................................................................2
2 - Introduction .............................................................................................................3
3 - Important Safety Information .....................................................................................4
4 - Boiler Ratings & Capacities .........................................................................................5
5 - Before Installing The Boiler ........................................................................................6
6 - Locating The Boiler ...................................................................................................7
7 - Near Boiler Piping .....................................................................................................9
8 - Combustion Air And Vent Pipe .................................................................................. 12
9 - Gas Supply Piping ................................................................................................... 17
10 - Electrical Wiring .................................................................................................... 19
11 - Controls And Accessories ....................................................................................... 21
12 - Boiler Startup ....................................................................................................... 23
13 - Operating Instructions ........................................................................................... 24
14 - Maintenance And Cleaning ..................................................................................... 25
Appendix A - Boiler Piping And Wiring ............................................................................ 27
Appendix B - Water Quality, Water Treatment and Freeze Protection ................................... 45
2.1 Introduction
• Boiler is certified in accordance with ANSI Z21.13 
American National Standards Institute) and CSA 
(Canadian Standards Association) 4.9.
• This appliance is a gas-fired direct vent modulating cast 
aluminum hot water boiler.
• Cast aluminum monoblock heat exchanger allows better 
heat transfer and thermal storage than similarly sized 
cast iron boilers resulting in higher efficiency. 
• The heating system water absorbs large amounts of 
heat from the cast aluminum heat exchanger, cooling 
flue gases and causing condensation.
• Sealed combustion, premix gas burner, and low flame 
temperature means reduced CO and NOx emissions, 
which contribute to cleaner and healthier environment.
• This appliance takes its combustion air directly from 
outdoors (sealed combustion) and does not compete 
with building occupants for fresh air.
2 - INTRODUCTION
• Sealed combustion (also known as “direct vent”) 
is safest and best way to obtain plenty of clean 
combustion air.
• Forced draft fan draws in outside combustion air, takes 
cooler flue gases from boiler unit and provides positive 
removal of flue gases from the building through readily 
available PVC and CPVC pipes. Canada use ULC S636 
Material.
• These low pressure gas-fired hot water boilers are 
design certified by CSA International for use with 
natural gas and propane gas.
• Boilers are constructed and hydrostatically tested 
for maximum working pressure of 50 psig (pounds 
per square inch gage) in accordance with A.S.M.E. 
(American Society of Mechanical Engineers) Boiler and 
Pressure Vessel Code Section IV Standards for heating 
boilers.
3