Siemens TRAFFIC CONTROLS TC12 Benutzerhandbuch
TC12 Installation, Commissioning & Maintenance Handbook
3.3.3.48 Enable 50-
pply. Note. This facility is included in PB391 issue 2
3.3.3.49 Display Control Data (GCD)
GCD (control byte number: 0 - 3) <enter>
g received from the instation
to be displayed in binary format.
3.3.3.50 Display Digital Input Data (GDI)
GDI (input port number: 0 - 3) <enter>
l inputs to be displayed in binary
format.
Note: If this command is used to display the state of digital inputs which have
displayed will fluctuate between 0 and
1 for the particular inputs with voltage sensors attached, as the mains
voltage waveform crosses the voltage sensor threshold during each mains
voltage waveform crosses the voltage sensor threshold during each mains
to display the value of the input at mains
IU (Input number 0-95)<enter> [PB392 issue 6 or later]
isplays what facility is
‘ - indicates that the
put has been assigne
or more of
p or the U loop of U/D unit ?.
‘C?’
Input is assigned to Count Unit ?
‘O?’
Input is assigned to Occupancy Unit ?
ount, or occupancy sites, the letters ‘a’ to ‘d’ are appended
‘Q?’
Input is assigned to Queue Unit ?
HIOCC Unit ?
Scoot Unit ?
Scoot Unit ?
‘L?’
Input is assigned as a Mains state for sensor ?
3.3.3.52 Display Firmware Identity and Issue state (GIC, KIC)
GIC<enter>
Comment:
Comment:
Displays Firmware Reference Number and Issue State.
0-50 V rms LMU Operation (KLV)
KLV=1 (0)
Comment: Set to 1 to enable LMU operation when a 50-0-50 V rms mains
supply is being monitored. The default value is 0 for a 240 V rms
mains su
firmware (and above).
mains su
firmware (and above).
Diagnostic Display Commands
Comment:
Enables the control data currently bein
Comment:
Enables the state of the OTU digita
voltage sensors attached, the value
cycle. Use the KDI command
3.3.3.51 Display Inputs use (GIU)
G
D
D
assigned to each input, e.g. Reply ‘S2
d to Scoot unit 2. This command can be used to check the
in
configuration of the inputs. For each input the command will display one
configuration of the inputs. For each input the command will display one
e following:
th
‘U?a’ or ‘U?u’
Input is assigned to the A loo
{For N+1 c
to identify up to four loops.}
to identify up to four loops.}
‘H?’
Input is assigned to
‘S?’
Input is assigned to
666/HE/43100/000
Page 109
Issue 9