Siemens TRAFFIC CONTROLS TC12 사용자 설명서

 

TC12 Installation, Commissioning & Maintenance Handbook 

pply. Note. This facility is included in PB391 issue 2 

 

GCD (control byte number: 0 - 3) <enter> 

g received from the instation 

to be displayed in binary format. 

 

GDI (input port number: 0 - 3) <enter> 

l inputs to be displayed in binary 

format. 

Note:  If this command is used to display the state of digital inputs which have 

 displayed will fluctuate between 0 and 

1 for the particular inputs with voltage sensors attached, as the mains 
voltage waveform crosses the voltage sensor threshold during each mains 

to display the value of the input at mains 

 

IU (Input number 0-95)<enter> [PB392 issue 6 or later] 

isplays what facility is

‘ - indicates that the 

put has been assigne

 or more of 

p or the U loop of U/D unit ?.  

‘C?’   

Input is assigned to Count Unit ? 

‘O?’ 

Input is assigned to Occupancy Unit ? 

ount, or occupancy sites, the letters ‘a’ to ‘d’ are appended 

‘Q?’ 

Input is assigned to Queue Unit ? 

HIOCC Unit ? 
Scoot Unit ? 

‘L?’ 

Input is assigned as a Mains state for sensor ? 

GIC<enter> 
Comment:  

Displays Firmware Reference Number and Issue State. 

 

KLV=1 (0) 

Comment:   Set to 1 to enable LMU operation when a 50-0-50 V rms mains 

supply is being monitored. The default value is 0 for a 240 V rms 
mains su
firmware (and above). 

 

Comment: 

Enables the control data currently bein

Comment: 

Enables the state of the OTU digita

voltage sensors attached, the value

cycle. Use the KDI command 

G
D

 assigned to each input, e.g. Reply ‘S2

d to Scoot unit 2. This command can be used to check the 

in
configuration of the inputs. For each input the command will display one

e following: 

th
 

‘U?a’ or ‘U?u’  

Input is assigned to the A loo

{For N+1 c
to identify up to four loops.}  

‘H?’ 

Input is assigned to 

‘S?’ 

Input is assigned to 

666/HE/43100/000  

Page 109 

Issue 9