Saleen 10-8002-C11790A Benutzerhandbuch

 

16

06-1303-B09915* 

Swaybar Front Assembly 

1 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Figure 1 

Figure 2 

1.  Put the new sway bar into the 

location where the stock sway bar 
went.  

2.  Align the bushing brackets over the 

existing studs. (Figure 2)  

3.  Fasten down the new sway bar using 

the stock nuts over the inboard studs 
and new bushings brackets. There are 
a total of four nuts. Use a 3/8” impact 
gun with a 15 mm socket. (Figure 2) 
Torque nuts to 52 ft-lbs. 

4.  Attach the ends of the sway bar to the 

bottom of the end links, and put the 
stock nut in place over each bottom 
end link stud. Tighten nut using the 
3/8” impact gun and 18 mm deep 
socket. Torque nuts to 85 ft-lbs. 

5.  Remove the white cover from the 

front strut decals. 

6.  Jack the front of the car up, remove 

the jack stands, and lower the car 
back to ride height. 

•  3/8” impact gun 

•  15 mm deep socket, 3/8” drive  

•  18 mm deep socket, 3/8” drive 
•  Ft-lb torque wrench, ½” drive 

•  15 mm deep socket, ½” drive 
•  18 mm deep socket, ½” drive 

Front of 
car