Psion Teklogix 9160 G2 Benutzerhandbuch

2.

Provide Network Settings.

Provide a new administrator password for clustered access points. For 
more information, see “Provide Network Settings” on page 49.

3.

Settings.

Click the Update button to activate the wireless network with these new 
settings. For more information, see “Update Basic Settings” on page 50.

4.5.1  Default Configuration

If you follow the steps above and accept all the defaults, the access point will have 
the default configuration described in “Default Settings For The 9160 G2 Wireless 
Gateway” on page 27.

4.6  What’s Next?

Next, make sure the access point is connected to the LAN, bring up some wireless 
clients, and connect the clients to the network. Once you have tested the basics of 
your wireless network, you can enable more security and fine-tune by modifying 
advanced configuration features on the access point.

4.6.1  Make Sure The Access Point Is Connected To The LAN

If you configured the access point and administrator PC by connecting both into a 
network hub, then your access point is already connected to the LAN. That’s 
it—you’re up and running! The next step is to test some wireless clients.

If you configured the access point using a direct wired connection via crossover 
cable from your computer to the access point, do the following:

1.

Disconnect the crossover cable from the computer and the access point.

2.

Connect a regular Ethernet cable from the access point to the LAN.

3.

Connect your computer to the LAN either via Ethernet cable or wire-
less client card.