Proxim AP-4000 Benutzerhandbuch

CLI Command Types

Syntax:
[Device-Name]>show <parameter>
[Device-Name]>show <group>
[Device-Name]>show <table>

Examples:
[Device-Name]>show ipaddr
[Device-Name]>show network
[Device-Name]>show mgmtipaccesstbl

Sets (modifies) the value of the specified parameter. To see a definition and syntax example, type only set and then press 
the Enter key. To see a list of available parameters, enter a space, then a question mark (?) after set (example: set?). 

Syntax:
[Device-Name]>set <parameter> <value> 
[Device-Name]>set <table> <index> <argument 1> <value 1> ... <argument N> <value N>

Example:

[Device-Name]>set sysloc “Main Lobby”
[Device-Name]>set mgmtipaccesstbl 0 ipaddr 10.0.0.10 ipmask 255.255.0.0 

Certain objects supported by the Access Point require a device reboot in order for the changes to take effect. In order to 
inform the end-user of this behavior, the CLI provides informational messages when the user has configured an object 
that requires a reboot. The following messages are displayed as a result of the configuring such object or objects.

The following message is displayed every time the user has configured an object that requires the device to be rebooted.

[Device-Name]>set ipaddr 135.114.73.10

ipaddr

In addition to the above informational message, the CLI also provides a message as a result of the exit, quit, or done 
command if changes have been made to objects that require reboot. If you make changes to objects that require reboot 
and execute the exit command the following message is displayed:

[Device-Name]>exit<CR> OR quit<CR> OR done<CR>

In general, you will use the CLI show Command to view current parameter values and use the CLI set Command to 
change parameter values. As shown in the following examples, parameters may be set individually or all parameters for a 
given table can be set with a single statement.