Proxim AP-4000 Benutzerhandbuch

Filtering

• Wired MAC Address: 01:00:5E:00:32:4B
• Wired Mask: FF:FF:FF:FF:FF:FF
• Wireless MAC Address: 00:00:00:00:00:00
• Wireless Mask: 00:00:00:00:00:00

Result: The Access Point does not forward any packets that have a destination address of 01:00:5E:00:32:4B to the 
wireless network.

You can configure the following advanced filtering options:

• Enable Proxy ARP: Place a check mark in the box provided to allow the Access Point to respond to Address 

Resolution Protocol (ARP) requests for wireless clients. When enabled, the AP answers ARP requests for wireless 
stations without actually forwarding them to the wireless network. If disabled, the Access Point will bridge ARP 
requests for wireless clients to the wireless LAN.

• Enable IP/ARP Filtering: Place a check mark in the box provided to allow IP/ARP filtering based on the IP/ARP 

Filtering Address and IP Mask. Leave the box unchecked to prevent filtering. If enabled, you should also configure the 
IP/ARP Filtering Address and IP/ARP IP Mask.
–

IP/ARP Filtering Address: Enter the Network filtering IP Address.

–

IP/ARP IP Mask: Enter the Network Mask IP Address.

The following protocols are listed in the Advanced Filter Table:

• Deny IPX RIP 
• Deny IPX SAP 
• Deny IPX LSP 
• Deny IP Broadcasts 
• Deny IP Multicasts 

The AP can filter these protocols in the wireless-to-Ethernet direction, the Ethernet-to-wireless direction, or in both 
directions. Click Edit and use the Status field to Enable or Disable the filter.

Port-based filtering enables you to control wireless user access to network services by selectively blocking TCP/UDP 
protocols through the AP. A user specifies a Protocol Name, Port Number, Port Type (TCP, UDP, or TCP/UDP), and 
filtering interfaces (Wireless only, Ethernet only, all interfaces, or no interfaces) in order to block access to services, such 
as Telnet and FTP, and traffic, such as NETBIOS and HTTP. 

For example, an AP with the following configuration would discard frames received on its Ethernet interface with a UDP 
destination port number of 137, effectively blocking NETBIOS Name Service packets.

1. Place a check mark in the box labeled Enable TCP/UDP Port Filtering.
2. Click Add under the TCP/UDP Port Filter Table heading.
3. In the TCP/UDP Port Filter Table

,

 enter the Protocol Names to filter.

UDP

137

NETBIOS Name 
Service

Ethernet

Enable