Proxim AP-4000 Benutzerhandbuch

Alarms

• Syslog Lowest Priority Logged: The AP will send event messages to the Syslog server that correspond to the 

selected priority number and any priority numbers below it. For example, if set to 6, the AP will transmit event 
messages labeled priority 0 to 6 to the Syslog server. This parameter supports a range between 0 and 7; 6 is the 
default.

• Syslog Heartbeat Status: When Heartbeat is enabled, the AP periodically sends a message to the Syslog server to 

indicate that it is active.

• Syslog Heartbeat Interval: If Syslog Heartbeat Status is enabled this field provides the interval for the heartbeat in 

seconds (between 1 and 604800). The default is 900 seconds.

• Syslog Host Table: This table specifies the IP addresses of a network servers that the AP will send Syslog messages 

to. Click Add to create a new entry. Click Edit to change an existing entry. Each entry contains the following field:
–

IP Address: Enter the IP Address for the management host.

–

Comment: Enter an optional comment such as the host name.

–

Status: The entry is enabled automatically when saved (so the Status field is only visible when editing an entry). 
You can also disable or delete entries by changing this field’s value.

The following messages are supported in the AP:

Auto Configuration using DHCP

6

Informational

Configuration filename and TFTP server address 
are obtained from DHCP when dynamic IP is 
configured on the device.

Auto Configuration using Static IP 6

Informational

Configured TFTP server address and configuration 
filename is used when Static IP is configured on 
the device.

TFTP Server IP and configuration 
filename not present in DHCP 
response

4

Minor

Configuration filename and/or TFTP server 
address is not present in the DHCP response when 
using DHCP.

TFTP Server IP Address used in 
AutoConfig feature

6

Informational

TFTP server IP address used for AutoConfig.

TFTP Server filename used in 
AutoConfig feature

6

Informational

TFTP filename used for AutoConfig.

Auto Configuration TFTP 
Download Failure

4

Minor

TFTP download of a configuration file for 
AutoConfig fails for the following reasons:
Incorrect or non-reachable TFTP server address
Incorrect or unavailable configuration filename
TFTP transfer timeout.

Image Compatibility Check, 
Invalid Image

2

Major

One of the following failures occurs:
Invalid Signature
Zero File Size
Large File
Non VxWork Image
Incompatible Image

AP Heartbeat Status

5

Informational

AP syslog keep alive message.