Trek TREK-725 Benutzerhandbuch
33
Chapter 4
Option(0) IP address
Choosing this option allows the configuration of the static IP address that
is used if DHCP is not enabled. This information is configured once and
stored in flash for subsequent downloads. The following prompt is dis-
played:
is used if DHCP is not enabled. This information is configured once and
stored in flash for subsequent downloads. The following prompt is dis-
played:
Enter new IP address:
You should enter a decimal representation of the IP address with each
byte separated by a decimal point. If you enter no data at the prompt, the
IP address is not changed. If you enter any numbers, they are used. Any
numbers not entered are expanded to zeros. That is, entering 255.255 at
the prompt resolves to 255.255.0.0.
byte separated by a decimal point. If you enter no data at the prompt, the
IP address is not changed. If you enter any numbers, they are used. Any
numbers not entered are expanded to zeros. That is, entering 255.255 at
the prompt resolves to 255.255.0.0.
Option (1) Subnet Mask
Choosing this option allows the configuration of the subnet mask that is
used in combination with the static IP address. Just like the IP address,
this information is configured once and stored into flash for subsequent
downloads. The following prompt is displayed:
used in combination with the static IP address. Just like the IP address,
this information is configured once and stored into flash for subsequent
downloads. The following prompt is displayed:
Enter new subnet mask:
You should enter a decimal representation of the mask with each byte
separated by a decimal point. If you enter no data at the prompt, the mask
is not changed. If you enter any numbers, they are used. Any numbers not
entered are expanded to zeros. That is, entering 255.255 at the prompt
resolves to 255.255.0.0.
separated by a decimal point. If you enter no data at the prompt, the mask
is not changed. If you enter any numbers, they are used. Any numbers not
entered are expanded to zeros. That is, entering 255.255 at the prompt
resolves to 255.255.0.0.
Option (2) NPE0 MAC Address
Choosing this option allows the configuration of the static MAC address
that is used for the NPE0 Interface. This information is configured once
and stored into flash for subsequent downloads. The following prompt is
displayed:
that is used for the NPE0 Interface. This information is configured once
and stored into flash for subsequent downloads. The following prompt is
displayed:
Enter new MAC address:
You should enter a hexidecimal representation of the MAC address with
each byte separated by a dash. If you enter no data at the prompt, the
MAC address is not changed. If you enter any numbers, they are used.
Any numbers not entered are expanded to zeros. That is, entering 80-86-
AA at the prompt resolves to 80-86-AA-00-00-00.
each byte separated by a dash. If you enter no data at the prompt, the
MAC address is not changed. If you enter any numbers, they are used.
Any numbers not entered are expanded to zeros. That is, entering 80-86-
AA at the prompt resolves to 80-86-AA-00-00-00.
Option (3) NPE1 MAC Address
This option is not used on TREK-725.
Option (4) RNDIS MAC Address
This option is not used on TREK-725.