Toshiba 18 - 1250 A Benutzerhandbuch

25 

The starter must be OFF in order to enter the Program Mode. 

Use the Program Mode to view or change Function (Fn) settings. To 
enter the Program Mode, press the [Fn] key once from the Status 
Screen described in 5.3.1 above. The first time you enter the Program 
Mode after power has been cycled to the starter, the initial function 
[F001] should display with the selected digit flashing. If the TE Series 
starter has been programmed and power to the unit has not been 
cycled, the readout will display the last function viewed or changed. To 
change to a different function, use the arrow keys.  

The programming of each individual Function can be viewed without 
making changes (values can also be viewed in the Run Mode, however 
no changes can be made). Each Function is signified by the letter “F” in 
the beginning of the data, the 4 digit value of the function follows after 
hitting the [READ/ENTER] key 

• 

[F001] The “F” indicates the programmable Function. 

• 

[0000] This is the present setting of the applicable function. This 

display may include decimals between digits depending on the function 
setting’s range and incremental steps. 

 

[0000.]   Indicates that Phase A is drawing no current  

(unit is in Off mode).  

[F001]   Indicates that this is Function 001 (Motor FLA). 

[0306]  Indicates that the programmed motor FLA is 

360 Amps. 

[F001]  Indicates that you have returned to the Function 

Select screen. 

[0000.]   Default screen. 

 

 

 
ƒ  NOTE:  

If password protection has been enabled, operator will need to 
obtain password access before function settings can be changed. 
See Section 5.6.12 and Appendix 3.