Tone Commander 6210 Benutzerhandbuch

Robust handset retainer clips for wall mount use are available on
request from Tone Commander.

Rotating the Base

The phone base must be rotated for wall mounting.

•

  Disconnect the line cord.

•

  Remove the retaining screw in the center of the base.

•

  Press the top of the tall edge of the base to disengage the snap

tabs, then lift the base from the telephone body.
Do not touch the expansion connector. If using the 6030X, 6001TA,
or 6002TA, leave the expansion cable plugged into the phone.

•

  Turn the base 180°, insert the tabs on the short edge of the base

into the holes near the display end of the telephone, and then snap
the tall side of the base onto the telephone.

•

  Replace the retaining screw (required for UL compliance).

Attaching to a wall mount jack

•

  Plug an 8”, 8-pin line cord into the S/T IN jack (6210/6220T) or the U

IN jack (6210/6220U) on the telephone. Route the cord under the
guide tabs on the base. If you do not have one, you can obtain an 8”
line cord by calling Tone Commander Technical Support at
(800) 524-0024.

•

  Hold the telephone next to the wall mount jack. Plug the line cord

into the jack.

•

  Hang the telephone on the wall plate mounting studs. Press down

firmly to lock in place.

•

  Push any excess line cord into the base.