Technicolor - Thomson ITC251 Benutzerhandbuch

Seite von 21
EN
10
Switching the TV set on and off
 To switch the TV set on, press the 
button located on the side of the set.The TV
set takes up to 40 seconds to come on.
If the indicator on the front is red, the set is in standby mode.You can then:
- press the 
or any numeric button on the remote control,
- press the 
TV
,
OK
or 
PR
+/
PR
-
buttons to switch the television on at the last channel
or AV programme you were watching,
- press the 
AV
button to switch the television on at the last AV programme you were
watching.
When the set is on, the indicator on the front is green or blue.
 To put the TV set in standby mode, press the 
button on the remote control.When
the set is in standby mode,the indicator on the front is red.The TV set remains
powered up, but with low energy consumption.
 To switch off the TV set, press the on/off button on the side of the set.
Note: The fan continues to run for about another two minutes after the TV set has been switched
to standby mode.
Volume
 Volume control: use the 
+/-
buttons on the front of the TV set or press the
relevant buttons on the remote control to increase or decrease the volume.
 Sound mute: press the 
button to temporarily mute the sound. Press this button
again or the 
+
button to restore it.
Displaying status information
In TV mode, press the yellow button (
INFO
) on the remote control to display the number
and name of the channel you are watching, the time, the type of sound, and the zoom or
format.
When you switch on the television or change channels, the number and name of the
channel are displayed.
Accessing channels
 Using the numeric buttons:
- for channels 1 to 9, press the corresponding button;
- for channels 10 to 99, press the 
0
button to display “
--
”, then enter the two digits.
 Using the 
PR
+/
PR
-
buttons: scroll through the channels. AV programmes are not
included in the cycle unless you use the buttons on the front of the TV set.
 Using the list of programmes: refer to page 11.
To access the channel or AV programme previously being watched, press the 
RETURN
button
Accessing AV  programmes
Press the 
AV
button to display the last selected audio-visual programme and scan through
the other audio-visual programmes.
Av selection loop: AV1, AV2, AV3, COMP, HDMI,VGA.
A
Chapter 3
General operation
itc251-en  2/02/06  11:42  Page 10