Nortel Networks Circuit Card Benutzerhandbuch
Page 88 of 906
Circuit card installation
9
If there is an enable/disable switch, set it to Enb.
Note: Do not enable the switch on an NT8D04 Superloop Network card
or QPC414 Network card until network loop cables are installed.
or QPC414 Network card until network loop cables are installed.
10 If you are adding a voice, conference, or tone and digit loop, press the
manual initialize (Man Int) button on the NT5D03 or the NT5D10 Call
Processor if the card is associated with the active Call Processor:
Processor if the card is associated with the active Call Processor:
Note: An initialization causes a momentary interruption in call
processing.
processing.
11 If you are installing the card in a working system, refer to the work order
and the Software Input/Output: Administration (553-3001-311) to add the
required office data to the system memory.
required office data to the system memory.
12 Go to the appropriate test procedure in “Acceptance tests” on