Nortel Networks Circuit Card Benutzerhandbuch

 Acceptance tests

Use this procedure to test a conference card or to test the conference function 
of an NT8D17 Conference/TDS card.

Log into the system:

LOGI (password)

Request the status of a loop on the conference card:

LD 38
STAT loop 

Conference status is formatted as follows:

CNFC n DSBL n BUSY
“n” represents the number of conference groups disabled and busy

CHAN n DSBL n BUSY
“n” represents the number of channels disabled and busy

UNEQ
card is not equipped in the system

DSBL
card is disabled in software

If the conference card loop is disabled, enable it.

For an NT8D17 Conference/TDS card, enter:
ENLX loop 
(the conference loop is the odd loop of the conference/TDS loop pair)

Note: The conference/TDS card is not enabled automatically when it is 
inserted. You must enable the card with the command ENLX. (This 
command is used in LD 34 and LD 46 to address even loops and in LD 38 
to address odd loops.) Enabling the loops with the command ENLL does 
not enable the hardware for the card.

For other than an NT8D17 Conference/TDS card, enter:
ENLL loop 
(the conference loop must be an even loop for cards other than the 
NT8D17)

If the system response is other than OK, see the Software Input/Output: 
Administration (553-3001-311) to analyze the messages.