Jenn-Air Built-in Coffee System JBC7624BS Benutzerhandbuch

Check approximately once a month that the feed funnel for 
ground coffee is not blocked.

Check the inside of the coffee system approximately once a 
week for dirt and debris. If necessary, remove coffee deposits 
with a damp sponge or cloth.

Clean the brewing unit every month.
IMPORTANT: The brewing unit cannot be removed while the 
coffee system is switched on. Do not attempt to use force to 
remove the brewing unit.
1. Make sure the coffee system is properly switched off. See the 

“Switching Off the Coffee System” section.

2. Open the service door on the front of the coffee system by 

pulling on the hot water and steam spout.

3. Remove the drip tray and the coffee grounds container.

4. Press the two red release buttons inward and pull the brewing 

unit out.

5. Soak the brewing unit in water for about 5 minutes, then 

rinse.
NOTE: Do not use any detergent to clean the brewing unit. 
The inside of the piston is treated with lubricant that 
detergent would remove.

6. After cleaning, reinsert the brewing unit so that the support 

and the pin at the bottom are fully engaged. Push the PUSH 
symbol until it clicks into place and the two red release 
buttons have clicked out.

NOTE: If you are having difficulty replacing the brewing unit, 
compress the moving parts from both the top and bottom as 
shown in the following illustration before reinserting it.

7. Replace the drip tray and coffee grounds container.
8. Close the service door.

A

B

A

B

A

B

A

B