Jenn-Air Built-in Coffee System JBC7624BS Benutzerhandbuch

TROUBLESHOOTING

The coffee is not hot

The cups have not been preheated.

Heat the cups by rinsing them with hot water.

The brewing unit has cooled down because 
2-3 minutes have elapsed since the last coffee was 
made.

Before making coffee, heat the brewing unit by 
selecting the Rinse function from the menu.

The set temperature is not high enough.

Change the set temperature. See “Coffee 
Temperature” in the “Settings” section.

The coffee is not 
creamy enough.

The coffee is ground too coarsely.

Turn the grinding coarseness adjustment knob one 
click counterclockwise toward the number 1 while 
the coffee mill is in operation. See the “Adjusting 
the Coffee Grinder” section.

The blend of coffee is unsuitable.

Use a blend of coffee specifically for espresso 
coffee machines.

The coffee runs out too 
slowly or in drips.

The coffee is ground too finely.

Turn the grinding coarseness adjustment knob one 
click clockwise toward the number 7 while the 
coffee mill is in operation. Continue one click at a 
time until coffee runoff is satisfactory. Results are 
only visible after making 2 cups of coffee. See the 
“Adjusting the Coffee Grinder” section.

The coffee runs out too 
quickly.

The coffee is ground too coarsely.

Turn the grinding coarseness adjustment knob one 
click counterclockwise toward the number 1 while 
the coffee mill is in operation. Results are visible 
only after making 2 cups of coffee. See the 
“Adjusting the Coffee Grinder” section.

The coffee does not run 
out of one or both of the 
spouts.

The spouts are blocked.

Clean the spouts with a toothpick.

The coffee comes out 
around the service door 
instead of from the 
spouts.

The holes in the spouts are clogged with dry coffee 
powder.

Clean the spouts with a toothpick, a sponge, or a 
hard-bristled kitchen brush.

The coffee feed inside the service door is blocked.

Clean the coffee feed thoroughly, especially around 
the hinges.

Water comes out of the 
spouts instead of 
coffee.

Ground coffee is blocking the funnel.

Clean the funnel with a wooden or plastic fork and 
clean the inside of the machine.

The milk does not come 
out of the milk spout.

The intake tube is not inserted or is inserted 
incorrectly.

Insert the intake tube in the rubber washer in the 
milk container lid.

The milk is not well-
frothed.

The milk container lid is dirty.

Clean the milk container lid as described in “To 
Clean Milk Frother” in the “Making Cappuccino” 
section.

The milk pointer is incorrectly positioned.

Adjust the pointer as described in the “Making 
Cappuccino” section.

The milk contains large 
bubbles or spurts out of 
the milk spout.

The milk is not cold enough or is not 2%.

For best results, use cold skim or 2% milk. If 
results are still not satisfactory, try changing brand 
of milk.

The milk frother pointer is incorrectly adjusted.

Move the pointer slightly toward the word 
“Caffelatte.” See the “Making Cappuccino” 
section.

The milk container lid is dirty.

Clean the milk container lid as described in “To 
Clean Milk Frother” in the “Making Cappuccino” 
section.