Hitachi US7070447-001 Benutzerhandbuch
Basic ATM Concepts
US7070447-001, Rev 01
11-9
Draft Level—Hitachi Confidential
Problem:
The CIP connection is up and active but I cannot ping across the
ATM network.
ATM network.
Solution:
Use the following solutions:
Verify that all IP addresses, subnet masks, and gateways are set
correctly on the VLANs and any attached devices
correctly on the VLANs and any attached devices
Verify the same subnet mask is being applied to the CIP and VLAN
interfaces.
interfaces.
/ATM/SHOW >cip <cip id>
/VLAN/SHOW/router
Verify any of the CIP IP addresses must be on a different IP subnet
than those VLANs existing on the HiSpeed switches.
than those VLANs existing on the HiSpeed switches.
/ATM/SHOW >cip <cip id>
/VLAN/SHOW/vlan
Verify the VLANs communicating with one another over ATM
belong to different IP subnets. VLANs belonging to the same IP
subnet are not allowed to communicate with one another via CIP.
belong to different IP subnets. VLANs belonging to the same IP
subnet are not allowed to communicate with one another via CIP.
/VLAN/SHOW/VLAN
If using PVC, verify the VCI values are identical on the HiSpeed
switches. However, the CIP index does not need to be the same on
both switches.
switches. However, the CIP index does not need to be the same on
both switches.
/ATM/SHOW >cip
Verify that RIP is active for CIP and verify all routes are being
learned.
learned.
/ATM/SHOW >cip <cip id>
/INET/SHOW >route