Hitachi US7070447-001 Benutzerhandbuch
Basic ATM Concepts
US7070447-001, Rev 01
11-11
Draft Level—Hitachi Confidential
–
Verify signaling and ILMI status should be ‘up’.
/ATM/SHOW >port
Verify the following using
/ATM/SHOW/connection:
–
OAM is up.
–
SSCOP, and ILMI is up. (for SVC only)
–
A Pt-Pt SVC or PVC connection is created per PTOP instance.
–
ATM port connection and signaling. Operational status, Line
state, Signaling status, and ILMI should be ‘up’. (for SVC only)
state, Signaling status, and ILMI should be ‘up’. (for SVC only)
/ATM/CONFIG/MODIFY> port
Verify the connection up time is increasing and status is ‘active’
for a specific VCC using
VAC <VCC number>
Problem:
The PTOP connection is up and active but I cannot ping across the
ATM network.
ATM network.
Solution:
Use the following solutions:
Verify that all IP addresses, subnet masks, and gateways are set
correctly on the VLANs and any attached devices
correctly on the VLANs and any attached devices
Verify the ATM port service has been bounded to each VLAN.
/PORTSERV/CONFIG/create 34
vps 34
Verify all ATMPTOP ports are in a ‘Forwarding’ state using vvp
If configuring PVC, ensure the VCI values are identical on the
switches you are connecting to.
switches you are connecting to.
Verify a PVC Pt-Pt connection is created.
/ATM/SHOW >connection
Note:
Depending on Spanning Tree, this process may take up to
20 seconds