Hitachi 3300MFP Benutzerhandbuch
114 8 Networking
EN
●
Netscape Navigator 4.6x, 4.7x, 6.0, or 6.1
For the latest list of compatible web browsers, check HP’s Customer Care online at
http://www.hp.com/support/net_printing.
http://www.hp.com/support/net_printing.
To start the embedded web server
After you establish an IP address on the print server, perform the following steps:
1
Run a supported web browser.
2
Enter the IP address of the print server as the URL. The print server’s home page displays.
3
Click the Help link on the web page for more information.
Note
If you change the IP address and other parameters, the connection to the embedded web server
closes. To re-establish a connection, use the new IP address as the URL. Also, some computer
setups may no longer work.
closes. To re-establish a connection, use the new IP address as the URL. Also, some computer
setups may no longer work.
Using HP Web JetAdmin
HP Web JetAdmin is a printer installation and management application for intranets. You can
obtain this software from HP Customer Care online at http://www.hp.com/support/net_printing.
obtain this software from HP Customer Care online at http://www.hp.com/support/net_printing.
Hewlett-Packard recommends that you use HP Web JetAdmin version 6.5 or later for operation
with the print server’s embedded web server.
with the print server’s embedded web server.
Using BOOTP
This section describes how to configure the print server using Bootstrap Protocol (BOOTP)
services on servers in some operating systems. BOOTP is used to download network
configuration data from a server to the HP Jetdirect print server over the network.
services on servers in some operating systems. BOOTP is used to download network
configuration data from a server to the HP Jetdirect print server over the network.
For BOOTP, the downloaded configuration data may also identify a file containing extended
configuration data. The HP Jetdirect print server downloads this file using TFTP. This TFTP
configuration file may be located on the BOOTP server or on a separate TFTP server.
configuration data. The HP Jetdirect print server downloads this file using TFTP. This TFTP
configuration file may be located on the BOOTP server or on a separate TFTP server.
Automatically downloading configuration data has the following benefits:
●
Ease of HP Jetdirect print server configuration. Complete network configuration can be
automatically downloaded each time the print server is powered on.
automatically downloaded each time the print server is powered on.
●
Ease of configuration management. Network configuration parameters for the entire network
can be in one location.
can be in one location.
●
Enhanced configuration control of the print server. Configuration by other methods is limited to
select parameters.
select parameters.
When the print server is powered on, it broadcasts requests that contain its hardware address. A
server daemon searches servers for configuration data with a matching hardware address, and if
successful, sends the corresponding configuration data to the print server as a reply.
server daemon searches servers for configuration data with a matching hardware address, and if
successful, sends the corresponding configuration data to the print server as a reply.
The factory-default state of the HP Jetdirect print server is to request its configuration data using
BOOTP requests first, and if no BOOTP reply is received, then to request its configuration data
using DHCP requests.
BOOTP requests first, and if no BOOTP reply is received, then to request its configuration data
using DHCP requests.
Note
If the print server and the BOOTP, TFTP, or DHCP server are located on different subnets, IP
configuration may fail unless the routing device supports “BOOTP Relay” (allows the transfer of
requests between subnets).
configuration may fail unless the routing device supports “BOOTP Relay” (allows the transfer of
requests between subnets).