CTC Store Switch SB142 Benutzerhandbuch

 

MNX10015 / Rev B 

 

 

4/11/2008  

8 

(Figure 9)

 

a.  Socket A – Positive (+ RED) connection for the dynamic acceleration and 

with output on the BNC “J1” and the (2) pin Output connectors. 

b.  Socket B – Negative (- BLACK) connection for the dynamic acceleration 

and volt output for temperature. 

c.  Socket C – Positive (+ WHITE) connection for the voltage output for 

temperature with output on the BNC “J2”, only. 

d.  Socket D – Shield/Drain wire connection that is directed to “Earth” ground. 

 

 

 

 
 
 
 
Dual Vibration with 4-20mA output and Dynamic outputs: 

(Figure 9A)

 

a.  Socket A – Positive (+ WHITE) connection for the dynamic acceleration 

and would output on the BNC “J1” and the (2) pin MIL output connectors. 

b.  Socket B – Negative (- BLACK) connection for the dynamic acceleration 

and 4-20mA velocity output. 

c.  Socket C – Positive (+ RED) connection for the 4-20mA signal, and would 

output to the BNC “J2”, (not used in this application).This setup requires 
optional (12) position plug in block (CTC #JB905-2A) to wire LP series 
sensor to the PLC/DCS system. The PLC/DCS system then provides the 
power for the loop in this setup, using CTC’s LP series sensors. (Figure 
9A) 

d.  Socket D – Shield/Drain wire connection that is directed to “Earth” ground. 

 

PLEASE NOTE: In this application, the portable data acquisition system 
needs to have sensor power turned off before collecting data. 
 
 
 
 
 
 
 
 
 
 
 
 

*NOTE: 

WHITE “A” terminals not used 

Signal Wire Outputs 

Optional Plug-in Block 
CTC part # JB905-2A 

Sensor 

Wire 

Inputs