Fagor BMF-200X Benutzerhandbuch

•  Do not install the refrigerator outdoors or 

where it can be exposed to rain. Install 
your appliance in a dry room and avoid 
high humidity areas such as basements 
and garages. 

•  Install the refrigerator away from heat 

sources and protect it from direct 
sunlight in order to conserve energy. 

• For 

suffi cient leveling and air circulation 

in the lower rear section of the appliance, 
the bottom feet may need to be adjusted. 
You can adjust them manually or by 
using a suitable spanner. 

•  The unit will not function properly if tilted 

more than 25/64” (10 mm). Please level 
the unit as fl at as possible.

For transportation convenience,  the door 
handles are separately packaged in a plastic 
bag. To install the handles, follow the steps 
below. 

1.  Remove screw covers on the left side of 

the door and put them into the plastic 
bag. 

2.  Place the handle on the left side of 

the door, keeping the screw holes in 
the handle and the door in line, as the 
picture shows.

3. Attach the handle with the special 

screws provided in the bag and then 
install the handle covers. 

The side which the door opens on can be 
changed from the right side (as supplied) 
to the left side. Disconnect the refrigerator 
from the power outlet and remove products 
stored on the inside of the door. 

WARNING: This procedure should only be 
carried out by qualifi ed individuals. Certain 
aspects of this procedure may require two 
people. 

Tools you will need:

Note: When laying the refrigerator on its 
back to gain access to the base, you should 
rest it on a soft foam pad or similar material to 
avoid damaging the back of the refrigerator. 
To reverse the door, the following steps are 
recommended. 

1.  With the refrigerator upright, open the 

upper door to take out all door racks (to 
avoid rack damage) and then close the 
door.

 

 

≤25/64” (10mm)

8mm socket wrench

8mm wrench

Flathead screwdriver

Phillips screwdriver