Cabletron Systems 9032578-02 Benutzerhandbuch

The SSR CLI has four access modes.

•

 – Allows you to display basic information and use basic utilities such as ping but 

does not allow you to display SNMP, filter and access control list information or make 
other configuration changes. You are in User mode when the command prompt ends 
with the 

>

 character: 

•

 – Allows you to display SNMP, filter, and access control information as well as 

all the information you can display in User mode. To enter Enable mode, enter the 
enable

 command, then supply the password when prompted. When you are in Enable 

mode, the command prompt ends with the 

#

 character: 

•

 – Allows you to make configuration changes. To enter Configure mode, first 

enter Enable mode (enable command), then enter the configure command from the 
Enable command prompt. When you are in Configure mode, the command prompt 
ends with

(config)

.

•

– This mode appears when the SSR the external flash card or the system image is 

not found during bootup. You should enter the reboot command to reset the SSR. If the 
SSR still fails to bootup, please call Cabletron Technical Support.

The command prompt will show the name of the SmartSwitch Router in front of 
the mode character(s). The default name is “ssr”. 

When you are in Configure or Enable mode, enter the exit command or press Ctrl+Z to 
exit to the previous access mode.

When you exit Configure mode, the CLI will ask you whether you want to 
activate the configuration commands you have issued. If you enter Y (Yes), the 
configuration commands you issued are placed into effect and the SmartSwitch 
Router’s configuration is changed accordingly. However, the changes are not 
written to the Startup configuration file in the Control Module’s boot flash and 
therefore are not reinstated after a reboot. 

Ctrl+F

Move cursor forward one character

Ctrl+N

Scroll to next command in command history (use the cli show 
history

 command to display the history)

Ctrl+P

Scroll to previous command in command history

Ctrl+U

Erase entire line

Ctrl+X

Erase from cursor to end of line

Ctrl+Z

Exit current access mode to previous access mode