Avocent Access Router Cyclades-PR1000 Benutzerhandbuch
Cyclades-PR1000
36
Chapter 4 - Step-by-Step Instructions
STEP THREE
The network protocol parameters, shown in Figure 4.14, are similar to those for the Ethernet interface. Fill in the
parameters for your network in the right-most column.
The network protocol parameters, shown in Figure 4.14, are similar to those for the Ethernet interface. Fill in the
parameters for your network in the right-most column.
Menu CONFIG=>INTERFACE=>SWAN=>NETWORK PROTOCOL=>IP
Parameter
Parameter
Example
Your Application
Active or Inactive
Active enables IP communication (IPX and
Transparent Bridge are not used in this
example).
Transparent Bridge are not used in this
example).
Interface Unnumbered/
Numbered
Numbered
Numbered
Primary IP Address
200.240.230.2
Subnet Mask
255.255.255.240 is the mask in the
example.
example.
Secondary IP Address
0.0.0.0 for none.
IP MTU
Use the preset value, 1500. This
determines whether or not a given IP
datagram is fragmented.
determines whether or not a given IP
datagram is fragmented.
IP Fragmentation - Ignore
Bit DF
Bit DF
Yes.
NAT
Global, because NAT is not being used in
this example.
this example.
ICMP Port
Inactive
Incoming Rule List
None, filters are not included in this
example.
example.
Outgoing Rule List Name
None, filters are not included in this
example.
example.
Routing of Broadcast
Messages
Messages
Inactive
FIGURE 4.14 SWAN NETWORK PROTOCOL (IP) MENU PARAMETERS