Avocent Access Router Cyclades-PR1000 Benutzerhandbuch
Cyclades-PR1000
37
Chapter 4 - Step-by-Step Instructions
STEP FOUR
The Encapsulation parameters for Frame Relay are less straight-forward. Many of them are based on decisions
that cannot be shown in a diagram. Fortunately, the choices made here will mostly affect the performance of the
link, rather than whether it works or not. Fill in the parameters appropriate for your system, consulting chapter 8
of the Installation Manual for more information if necessary.
The Encapsulation parameters for Frame Relay are less straight-forward. Many of them are based on decisions
that cannot be shown in a diagram. Fortunately, the choices made here will mostly affect the performance of the
link, rather than whether it works or not. Fill in the parameters appropriate for your system, consulting chapter 8
of the Installation Manual for more information if necessary.
Menu CONFIG=>INTERFACE=>SWAN=>ENCAPSULATION=>FRAME RELAY
Parameter
Parameter
Example
Your Application
Encapsulation Type
Choose RFC1490 unless the router at the
other end of the connection uses the default
Cisco standard.
other end of the connection uses the default
Cisco standard.
SNAP IP
Inactive for the example. The router on the
sending end must be using the same header
type (NLPID or SNAP) as the router on the
receiving end.
sending end must be using the same header
type (NLPID or SNAP) as the router on the
receiving end.
LMI
ANSI for the example. This must also be
the same as the router on the receiving end.
the same as the router on the receiving end.
T391
Ten seconds, the interval between the LMI
Status Enquiry messages.
Status Enquiry messages.
N391
Six.
N392
Three.
N393
Four. This value must be larger than N392.
Bandwidth Reservation
Inactive. Traffic control will not be covered
in this example
in this example
FRF-12 - Fragment Size
Indicates the size of FRF-12 fragments.
Use default value.
Use default value.
Voice over this link
Inactive.
FIGURE 4.15 FRAME RELAY ENCAPSULATION MENU PARAMETERS