Aruba Networks Access Point Aruba AP 60/61 Benutzerhandbuch
Troubleshooting
Appendix A
Appendix A
32
Aruba AP 60/61
0500160
Installation Guide
December 2005
Use a Telnet client on your management workstation to connect to
theMobility Controller IP address using logical port 2300. The connection
command may vary depending on the specific software used, but commonly
appears as follows:
theMobility Controller IP address using logical port 2300. The connection
command may vary depending on the specific software used, but commonly
appears as follows:
2.
When prompted, log in to the Mobility Controller as the administrator:
This will present you with the Mobility Controller SOE console prompt:
3.
Connect to the Mobility Controller port to which the Aruba AP 60/61 is
physically attached:
physically attached:
where
slot number is the physical slot of the line card in the Mobility Controller, and
port number is the physical port.
If the AP has not finished booting, allow the Autoboot timer to expire. When the
device has booted, the AP support prompt (
device has booted, the AP support prompt (
#) will appear.
Direct Terminal Connection
This method requires that the Aruba AP 60/61 is connected to a compatible serial
console using the Aruba serial breakout adapter (see
console using the Aruba serial breakout adapter (see
1.
Set up your local terminal.
This procedure requires a terminal or computer running terminal emulation
software with the following settings:
software with the following settings:
2.
Establish console communication.
>
telnet <Mobility Controller IP address> 2300
user: admin
password: <administrator password (not displayed)>
password: <administrator password (not displayed)>
Available commands:
baud [9600|19200|38400|57600|115200]
connect <slot/port>
exit (no args)
soe>
baud [9600|19200|38400|57600|115200]
connect <slot/port>
exit (no args)
soe>
soe>
connect <slot number>/<port number>
T
ABLE
A-1
Console Terminal Settings
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
9600
8
None
1
None