Apollo SWING GATE OPERATOR 1500 Benutzerhandbuch

8 

Mount the control box within 4 feet of the pivot arm. 
Use mounting hardware capable of supporting the 
weight of the control box with the battery installed. 
 
Mounting holes are not provided since mounting 
surfaces will vary. 

Set battery inside of control box with terminals 
toward the front (Do not use any battery with side 
terminals). 

Connect actuator cable to the “MASTER” connector on the 
control board.  
 
If a 1600 is being installed and conduit is being used under 
the drive (recommended), cut the slave (opposite side 
where control box is mounted) actuator cable about 12” 
from the white connector. Run the remaining cable across 
the drive through conduit and up through the control box. 
Cutoff any excess cable and splice the short piece back to 
the cable. Connect to the “SLAVE” connector on the control 
board. 
 
Connect the RED power wire (s) to the battery positive ( + ) 
and the BLACK power wire (s) to the battery negative ( - )

 

1/2” x 3 1/2” Hex Bolt 

1/2” Washer 

1/2” Lock Nut