Alvarion BreezeMAX Wi and BreezeACCESS Wi 214486 Benutzerhandbuch
System Logging Commands
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
161
5.6
System Logging Commands
These commands are used to configure system logging on the AP.
5.6.1
logging on
This command controls logging of error messages; i.e., sending debug or error
messages to memory. The no form disables the logging process.
messages to memory. The no form disables the logging process.
Syntax
[no] logging on
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to memory. You can use the logging level
command to control the type of error messages that are stored in memory.
command to control the type of error messages that are stored in memory.
Example
5.6.2
logging host
This command specifies syslog servers host that will receive logging messages.
Use the no form to remove syslog server host.
Use the no form to remove syslog server host.
Table 5-7: System Logging Commands
Command
Function
Mode
Page
logging on
Controls logging of error messages
GC
logging host
Adds a syslog server host IP address that will receive
logging messages
GC
logging console
Initiates logging of error messages to the console
GC
logging level
Defines the minimum severity level for event logging
GC
logging facility-type
Sets the facility type for remote logging of syslog messages
GC
logging clear
Clears all log entries in AP memory
GC
show logging
Displays the state of logging
Exec
show event-log
Displays all log entries in AP memory
Exec
Enterprise AP(config)#logging on
Enterprise AP(config)#