Alvarion BreezeMAX Wi and BreezeACCESS Wi 214486 Benutzerhandbuch

 

56

Operation

Chapter 4 - System Configuration

SSH client software needs to be installed on the management station to access the 
AP for management via the SSH protocol.

Telnet Server Status – Enables or disables the Telnet server. (Default: Enabled)

SSH Server Status – Enables or disables the SSH server. (Default: Enabled)

SSH Server Port – Sets the UDP port for the SSH server. (Range: 1-65535; 
Default: 22)

To enable the SSH server, use the ip ssh-server enable command from the CLI 
Ethernet interface configuration mode. To set the SSH server UDP port, use the ip 
ssh-server port command. To view the current settings, use the show system 
command from the CLI Exec mode (not shown in the following example).

„

The AP supports only SSH version 2.0.

„

After boot up, the SSH server needs about two minutes to generate host encryption keys. The 
SSH server is disabled while the keys are being generated.

Enterprise AP(if-ethernet)#no ip telnet-server

Enterprise AP(if-ethernet)#ip ssh-server enable

Enterprise AP(if-ethernet)#ip ssh-server port 1124

Enterprise AP(if-ethernet)#exit

Enterprise AP(config)#