ACS Food Saver A0571050 Benutzerhandbuch
Pumps & Conveying System Components Chapter 4: Operation
36
High Vacuum Relief Regulator Operation
A factory-set pressure regulator is installed on the pump package vent valve as a mechanical
back-up safety feature. It protects the pump motor from damage during high vacuum
conditions if an undetected failure of the vacuum switch should occur. The regulator is set to
limit system vacuum to 15” Hg (475 millibars) by allowing the vent valve plunger to shift
and vent the pump.
A factory-set pressure regulator is installed on the pump package vent valve as a mechanical
back-up safety feature. It protects the pump motor from damage during high vacuum
conditions if an undetected failure of the vacuum switch should occur. The regulator is set to
limit system vacuum to 15” Hg (475 millibars) by allowing the vent valve plunger to shift
and vent the pump.
Note: Do not adjust the pressure regulator. Adjusting the pressure regulator
voids your warranty.
4-3 Shut-down
To deactivate the conveying system:
1. Turn the disconnect switch at each pump or component to OFF. This will take each
pump or component offline.
2. Turn off the compressed air supply to the system.
Note: Consult your specific controller operation and instruction manual for
specific shut-down information for your conveying system.