Accton Technology Media Converter EC3802-WDM Benutzerhandbuch
Port and Cable Assignments
26
5.
Click Apply to start the download process. After the download process is
completed, the following message will be displayed.
completed, the following message will be displayed.
Upgrade Successful, Rebooting ...
Please wait a minium of 30 seconds while the system restarts.
Please wait a minium of 30 seconds while the system restarts.
6.
After the system restarts, the Default Page is displayed. Click System, and then
click Firmware Upgrade to verify that the new firmware is now loaded in the CPE.
click Firmware Upgrade to verify that the new firmware is now loaded in the CPE.
Port and Cable Assignments
RJ-45 Ethernet Port
Caution: DO NOT plug a phone jack connector into any RJ-45 port. Use only twisted-pair
cables with RJ-45 connectors that conform with FCC standards.
An Ethernet twisted-pair link segment requires two pairs of wires. Each wire pair is
identified by two different colors. Each wire pair must be attached to the RJ-45
connector in a specific orientation detailed below.
identified by two different colors. Each wire pair must be attached to the RJ-45
connector in a specific orientation detailed below.
The RJ-45 Ethernet port on the FTTH CPE can be set as an MDI or MDI-X port,
which allows straight-through cable to be used for a connection to a computer,
switch/hub, or other network device. In straight-through cable, pins 1, 2, 3 and 6 at
one end of the cable, are connected straight-through to pins 1, 2, 3 and 6 at the
other end of the cable.
which allows straight-through cable to be used for a connection to a computer,
switch/hub, or other network device. In straight-through cable, pins 1, 2, 3 and 6 at
one end of the cable, are connected straight-through to pins 1, 2, 3 and 6 at the
other end of the cable.
Pin
MDI-X Signal Name
MDI Signal Name
1
Receive Data plus (RD+)
and GND (Positive V
port
)
Transmit Data plus (TD+)
and -48V feeding power (Negative V
port
)
2
Receive Data minus (RD-)
and GND (Positive V
port
)
Transmit Data minus (TD-)
and -48V feeding power (Negative V
port
)
3
Transmit Data plus (TD+)
and -48V feeding power (Negative V
port
)
Receive Data plus (RD+)
and GND (Positive V
port
)
4
GND (Positive V
port
)
-48V feeding power (Negative V
port
)
5
GND (Positive V
port
)
-48V feeding power (Negative V
port
)
6
Transmit Data minus (TD-)
and -48V feeding power (Negative V
port
)
Receive Data minus (RD-)
and GND (Positive V
port
)
7
-48V feeding power (Negative V
port
)
GND (Positive V
port
)
8
-48V feeding power (Negative V
port
)
GND (Positive V
port
)