DSCover Satellite Products Home Security System SCW904x Benutzerhandbuch

Refer to Appendix E: Troubleshooting Guide, for troubleshooting assistance and a detailed description of all trouble conditions.

Pressing the scroll <> keys will display an “Alarms in Memory” message if an alarm occurred during the last armed period. Pressing [ ][3] will 
display the message “Scroll to view Alarms”. Scrolling will display the zones that went into alarm. To clear the Memory, arm then disarm the 
system. 

Press [ ][4]. The keypad will emit 3 rapid beeps to indicate that the door chime feature is now enabled and a steady 2-second tone if it is now dis-
abled. The same function can be performed by pressing and holding the Chime function button for 2 seconds.

The following table identifies available user codes:

Press [ ][5] followed by the Master Code. The keypad will display the first user (user 01) and include the letter ‘P’ if the user code is pro-
grammed. Scroll to the appropriate user and press the [ ] key to program the user (or enter the 2-digit user number). Enter a new 4 or 6-digit user 
code or press [ ] to delete the user code. After the user code is programmed or deleted, scroll to another user or press [#] to exit.

Press [ ][5] followed by the Master Code or Supervisor Code. Press [9] followed by the 2-digit user to change to the user attributes. 

Supervisor’s Code
This attribute makes the code valid when entering the [ ][5] User Code Programming section and [ ][6] User 

Functions. Note, these codes can only program codes which have equal or lesser attributes. This attribute will also 
allow this user to create bypass groups if an access code is required to enter into [ ][1] Bypassing.

Duress Code

Duress codes are standard user codes that will transmit the Duress Reporting Code whenever the code is entered to 
perform any function on the system. 

User can manually bypass zones if Bypassing requires an access code.

Future Use

The panel will squawk the bell output when the user arms or disarms when in Away Armed mode.

One-time Use Code

The One-time-use Code allows unlimited arming but only permits a single disarming once a day. 
The Disarm function is restored at midnight.

To change the user attributes, press the number corresponding to the attribute or scroll to the desired attribute and press [ ]. When the correct 
attributes are assigned to the user, press [#] to exit. To change the user attributes for another user, press [9] followed by the 2-digit user number. 
When finished, press [#] to exit.

Press [ ][6] followed by the Master Code, then press the number corresponding to the following functions or scroll to the desired option, then 
press [ ].

General User Codes
Master Code

Arm, disarm, attribute functions
All functions, arm, disarm, program user codes

Program Time and Date:  Enter the time and date using the following format [HH:MM] [MM/DD/YY].  Program the time using 
military standard (e.g., 8:00 pm = 20:00 hours).

WWW.DIYALARMFORUM.COM