DSCover Satellite Products Home Security System SCW904x Benutzerhandbuch

For a list of the defaults value programmed when the unit is shipped from the factory and for any other programming information refer to Appendix D: False 
Alarm Reduction.

Call Waiting Cancel (Section [382], Option 4) feature on a non-Call Waiting line will prevent successful communication to the supervising station.
Fire Alarm Verification feature (Auto Verified Fire Zone type [89]) is supported on the DSC Wireless Smoke Detector, Model WS4916. The fire alarm delay 
is 40s.

Programming at installation may be subordinate to other UL requirements for the intended application
Cross zones have the ability to individually protect the intended area (e.g. motion detectors which overlap)
Cross zoning is not recommended for line security Installations nor is to be implemented on exit/entry zones.
There is a communication delay of 30 seconds in this control panel. It can be removed, or it can be increased up to 45 seconds at the option of the end user by 
consulting with the installer.
Do not duplicate any reporting codes. This applies for all communication formats other than SIA or CID sending automatic programmed reporting codes.
The security system shall be installed with the sounding device activated and the communicator enabled for transmission using SIA or CID format.

This product is in conformity with:

EMC Directive 89/336/EEC based on results using harmonized stan-
dards in accordance with article 10(5), 

R&TTE Directive 1999/5/EC based on following Annex III of the direc-
tive and 

LVD Directive 73/23/EEC as amended by 93/68/EEC based on results 
using harmonized standards.

The product is labeled with the CE mark as proof of compliance with the 
above mentioned European Directives. Also a CE declaration of confor-
mity (DoC) for this product can be found at www.dsc.com under Agency 
Listings section.

The following is a list of warnings applicable when this equipment is connected to the New Zealand Telecom Network. 

The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with minimum con-
ditions for connection to its network. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, 
it provides no assurance that any item will work correctly in all respects with another item of Telepermitted equipment of a different make or 
model, nor does it imply that any product is compatible with all of Telecom's network services.

Decadic signalling should not be used as it is being progressively phased out of the network. DTMF dialling is 100% available and it should 
always be used.

This equipment is set up to carry out test calls at pre-determined times. Such test calls will interrupt any other calls that may be set up on the line 
at the same time. The timing set for such test calls should be discussed with the installer.
The timing set for test calls from this equipment may be subject to 'drift'. If this proves to be inconvenient and your calls are interrupted, then the 
problem of timing should be discussed with the equipment installer. The matter should NOT be reported as a fault to Telecom Faults Service.

During dialling, this device unit does not provide DC voltage to the series port connection and this may cause loss of memory functions for the 
terminal devices (local telephone) connected to T-1, R-1.

This device only responds to Distinctive Alert cadences DA1 and DA2.

This DSC SCW9047-433 
Security System may be 
connected to the Telecom 
Network 

PTC XXX / XX / XXX

X.

X 

= 

N

R

This DSC SCW9045-433 
Security System may be 
connected to the Telecom 
Network 

PTC XXX / XX / XXX

X.

X 

= 

N

R

WWW.DIYALARMFORUM.COM