Benq SX912 Benutzeranleitung

Operation

27

If the password function is activated, you will be asked 

to enter the five-digit password every time you turn on 

the projector. If you enter the wrong password, the 

password error message as pictured to the right 

displays lasting for three seconds, and the message 

'INPUT PASSWORD' follows. You can retry by 

entering another five-digit password, or if you did not 

record the password in this manual, and you absolutely do not remember it, you can use 

the password recall procedure. See 

 

for details.

If you enter an incorrect password 5 times in succession, the projector will automatically 

shut down in a short time.

1.

Press and hold AUTO on the projector or 
remote control for 3 seconds. The 
projector will display a coded number on 
the screen.

2.

Write down the number and turn off your 
projector.

3.

Seek help from the local BenQ service 
center to decode the number. You may be 
required to provide proof of purchase 
documentation to verify that you are an 
authorized user of the projector.

1.

Open the OSD menu and go to the System Setup: Advanced > Security 
Settings > Change password menu.

2.

Press MODE/ENTER. The message 'INPUT CURRENT PASSWORD' displays.

3.

Enter the old password.
• If the password is correct, another message 'INPUT NEW PASSWORD' 

displays. 

• If the password is incorrect, the password error message displays lasting for three 

seconds, and the message 'INPUT CURRENT PASSWORD' displays for 
your retry. You can press MENU/EXIT to cancel the change or try another 
password.

4.

Enter a new password.

The digits being input will display as asterisks on-screen. Write your selected password down here in this 

manual in advance or right after the password is entered so that it is available to you should you ever forget it.

Password: __ __ __ __ __
Keep this manual in a safe place.

5.

Confirm the new password by re-entering the new password.