Barco Projector 26-0313000-00 Benutzerhandbuch

Seite von 432
Encore Presentation System  •  User’s Guide  •  Rev 04
285
6.  System Setup
Output Format Setup
lìíéìí=cçêã~í=pÉíìé
Encore system setup:  Step 12 
S
Prerequisites
 — Ensure that you are familiar with the Output Menu.  In 
Chapter 5, refer to the “
” section on page 160.
In this procedure, you will configure the output format for each Video Processor and 
ScreenPRO-II that is used in your system.  
„
Use the following steps to set up the Encore output format:
1. 
On the Destination Bus, select the destination that you want to configure.
2. 
In the System Keypad, press OUTPUT to display the Output Menu.  At least one 
destination must be active in order to access the menu.
3. 
On the Format line, select the resolution and frame rate at which you want to 
drive the destination’s projector(s).  To minimize synchronization problems, select 
a frame rate that is consistent with your input sources.
4. 
Press 
{
APPLY FORMAT
}
 to accept the selection. 
5. 
Repeat from step 2 to set additional destination output formats.  
6. 
In the System Keypad, press SAVE to save the new configuration in memory.  
12
Important
Be sure to select your projector’s native resolution and a 
frame rate that is consistent with your inputs — for example, if 
you are using 59.94 NTSC video inputs, run the output at the 
same rate in order to be synchronous. 
To guarantee absolute "sync" of Input vs. Output, ensure 
that you genlock the Video Processors.  Refer to the 
” section on page 287 for details.  
Note
Automatic "Saves" occur as necessary, for example, when 
you change output resolutions.