Barco Projector 26-0313000-00 Benutzerhandbuch
Encore Presentation System • User’s Guide • Rev 04
287
6. System Setup
Genlock Setup
dÉåäçÅâ=pÉíìé
Encore system setup: Step 14
S
Prerequisites
— Ensure that you are familiar with the Genlock Menu. In
In this procedure, you will set up Genlock for each destination.
Use the following steps to set up Genlock:
1.
In the System Keypad, press OUTPUT to display the Output Menu.
2.
On the Destination Bus, select the destination that you want to configure.
3.
Press
{
GLCK
}
to display the Genlock Menu.
4.
For all types of destinations, set the genlock source on the Source line. Choose
between Black Burst, CSync or None.
between Black Burst, CSync or None.
5.
For ScreenPRO-II destinations only, verify the setting of the ScreenPRO-II’s
Termination Switch on the Termination line. The menu prompts you how to
change this physical switch on the ScreenPRO-II itself, if required.
Termination Switch on the Termination line. The menu prompts you how to
change this physical switch on the ScreenPRO-II itself, if required.
6.
Press
{
BACK
}
to return to the Output Menu.
7.
Repeat from step 2 to set additional destination genlock types.
8.
In the System Keypad, press
{
SAVE
}
to save the new configuration in memory.
14
Note
When you select the Source, the Type line automatically
displays the type of genlock provided.
displays the type of genlock provided.