Barco Projector 26-0313000-00 Benutzerhandbuch
Encore Presentation System • User’s Guide • Rev 04
289
6. System Setup
Projector Setup
11.
Once the projector is properly set, turn the Raster Box and the Mode off.
12.
Press
{
BACK
}
to return to the Output Menu.
13.
Repeat from step 2 for additional single screen destination projector setups.
14.
When all projectors for single screen destinations have been set up, press SAVE
in the System Keypad to save the new configuration in memory.
in the System Keypad to save the new configuration in memory.
táÇÉ=pÅêÉÉå=mêçàÉÅíçê=pÉíìé
Use the following steps to set up projectors for a wide screen application. This
procedure affects all projectors assigned to the selected destination.
procedure affects all projectors assigned to the selected destination.
1.
If you elected to use the Configurator application to assist with your widescreen
setup parameters, ensure that you have completed the following steps:
setup parameters, ensure that you have completed the following steps:
a.
On the Configurator’s Show Layout Tab, click the radio buttons for the
Encore Presentation System and your desired show layout.
Encore Presentation System and your desired show layout.
b.
On the Configurator’s Screen Details Tab, click the large “W” to display
the Wide Screen Parameters Window.
the Wide Screen Parameters Window.
c.
In the Wide Screen Parameters Window, enter your screen’s H and V
dimensions and the number of projectors.
dimensions and the number of projectors.
d.
Click Calculate to determine the required overlap.
e.
Make a note of these values. You will transfer them to the Controller’s
Wide Screen Settings Menu
Wide Screen Settings Menu
in the following steps.
2.
In the System Keypad, press OUTPUT to display the Output Menu.
3.
On the Destination Bus, select the wide screen destination whose projectors you
want to configure.
want to configure.
4.
Press
{
TEST PATTERN
}
to display the Test Pattern Menu.
5.
On the Output Monitor line, select the output(s) on which you want a test pattern
to appear — All, Preview, Program 1 or Program 2.
to appear — All, Preview, Program 1 or Program 2.
6.
On the Mode line, select On.
7.
On the Type line, select the Burst test pattern.
8.
On the Raster Box line, select On.
9.
Press
{
BACK
}
to return to the Output Menu.
10.
Press
{
WIDE SCREEN
}
to display the Wide Screen Settings Menu. Note that
the Total Projectors line shows the total number of Video Processors as defined
on the Destination Setup Menu.
on the Destination Setup Menu.
11.
Scroll to the Total H Res line and enter the total number of horizontal pixels in the
overall wide screen display.
overall wide screen display.
12.
Scroll to the Background Format line and select the method by which your
background graphics were originally produced: Edge-butted or Overlapped.
background graphics were originally produced: Edge-butted or Overlapped.
Note
This procedure also applies to a wide screen “stack”
destinations.
destinations.